Components

The computer sends an image to the projector through a RGB or VGA cable.  The projector transmits the image onto the interactive whiteboard.  The board relays any input messages (use of pen tools or hand) to the computer through a USB cable.

When you press the board with a pen tool or your finger, the top layer of the screen makes contact with the back layer of the screen.  Press with intent to ensure that your actions are recognized by the back layer.

Safety

• Never look directly at the projector’s light beam.
• Never touch the projector. It can become very hot during operation.
• Never use a chair to increase a student’s reach on the SMART^TM board.
• Never use other writing utensils (markers, pencils, ink pens, etc.) on the board. Keep these materials and others (scissors, liquids, etc.) away from the area.
• Be mindful of cords and the legs on portable models.

 

Cleaning and Orienting

Glass Plus^R Multi-Surface Cleaner and a soft paper towel or cloth are recommended for cleaning the board.  This should be done as needed.  Try to make it a habit to clean and orient your board once a week.

Etiquette

Only one user can touch the board at a time.  Since only one point of contact can be recognized by the board, so you may need to adjust how you hold the pen tools when writing.  Do not rest your hand on the board.  If you are right-handed, it is best to stand on the right side of the board.  This way your body will open up to your audience.

The Pen Tray

The four SMART^TM Board pens are simply hollow plastic tubes.  Optical sensors on the pen tray notify the computer when a pen is removed.  If you pick up two or more tools without returning the others, the board will recognize the last tool selected.

One pen try button will launch the keyboard.  The second button allows you to access right-click.  Pressing them both at the same time will open the orientation screen to align the board with the projector.

Indicator Lights

The status light (ready light) is located on the bottom right side of your SMART^TM Board.

Color of Light	Status
Not Lit	The board does not have power. Check the USB connections.
Solid Green	The board is communicating with the computer
Flashing Green	The SMARTTM  Board driver isn’t installed, or it isn’t running.  Try installing it from www.smarttech.com. If it continues to flash, contact your SMARTTM support representative for assistance.
Solid Red	The board has power, but it is not communicating with the computer. The light briefly turns red while powering up.  This is normal.
Flashing Amber	This occurs when you are updating firmware.  This is normal.
Solid Amber	This signifies a problem state.  Try disconnecting and reconnecting the USB cable at the board.